SECTION 501-12: Instrument Panel and Console
| 2014 Mustang Workshop Manual
|
REMOVAL AND INSTALLATION
| Procedure revision date: 01/07/2013
|
Instrument Panel Finish Panel — Center
NOTE:
Navigation shown, without navigation similar
| Item
| Part Number
| Description
| | 1
| 14401
| Center instrument panel finish panel electrical connectors
|
| 2
| —
| Center instrument panel finish panel retaining clip (part of 04302) (6 required)
|
| 3
| 04302
| Center instrument panel finish panel
|
| 4
| W705314
| Center instrument panel finish panel screw (2 required)
|
Removal and Installation
Vehicles with manual transmission
- Place the gearshift lever in the NEUTRAL position.
- Remove the gearshift lever knob.
- Turn the gearshift lever knob in a counterclockwise direction.
Vehicles with automatic transmission
- Place the selector lever in the NEUTRAL position.
NOTICE:
When prying on a component, a non-marring tool must be used or damage to the component may occur.
Remove the selector lever bezel.
- With a non-marring tool, lift the selector lever bezel upward.
All vehicles
- Open the storage compartment door.
- Remove the floor console finish panel.
- Lift the floor console finish panel upward to release the retaining clips.
- Disconnect the traction/hazard/trunk switch electrical connector.
- Disconnect the 2 ambient light electrical connectors, if equipped.
- Remove the 2 center instrument panel finish panel screws.
NOTICE:
When prying on a component, a non-marring tool must be used or damage to the component may occur.
Remove the center instrument panel finish panel in the following sequence.
- With a non-marring tool, pry outward on the center instrument panel finish panel to release the retaining clips.
- Disconnect the center instrument panel finish panel electrical connector(s).
- To install, reverse the removal procedure.
- Be sure that all electrical connectors are securely fastened before installing the center instrument panel finish panel.
