SECTION 501-14: Handles, Locks, Latches and Entry Systems
2014 Mustang Workshop Manual
GENERAL PROCEDURES
Procedure revision date: 01/07/2013

Autolock and Auto-Unlock Programming

Programming the Autolock Feature Using the Door Lock Control Switch

NOTE: The autolock feature can be enabled or disabled independently of the auto-unlock feature.

NOTE: Make sure that the perimeter alarm is not armed, the key is in the OFF position and the doors are closed.

NOTE: The following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.

  1. Turn the ignition key from the OFF to the RUN position.
  1. Press the unlock button on the door lock control switch 3 times.
  1. Turn the ignition key from the RUN to the OFF position.
  1. Press the unlock button on the door lock control switch 3 times.
  1. Turn the ignition key to the RUN position. The horn chirps once to indicate that programming mode is entered.
  1. To enable/disable the autolock feature, press the unlock button on the door lock control switch then the lock button. The horn chirps once if the autolocks are disabled or twice (one short chirp followed by a long chirp) if the autolocks are enabled.
  1. Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.

Programming the Auto-Unlock Feature Using the Door Lock Control Switch

NOTE: The auto-unlock feature can be enabled or disabled independently of the autolock feature.

NOTE: Make sure that the perimeter alarm is not armed, the key is in the OFF position and the doors are closed.

NOTE: The following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.

  1. Turn the ignition key from the OFF to the RUN position.
  1. Press the unlock button on the door unlock control switch 3 times.
  1. Turn the ignition key from the RUN to the OFF position.
  1. Press the unlock button on the door lock control switch 3 times.
  1. Turn the ignition key to the RUN position. The horn chirps once to indicate that programming mode is entered.
  1. To enable/disable the auto-unlock feature, press the lock button on the door lock control switch then the unlock button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a long chirp) if auto-unlock is enabled.
  1. Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.