Wipers and Washers

Windshield Wiper

The windshield wiper system consists of the following components:

• Washer pump and reservoir (located behind the RH fender)
• Windshield wiper pivot arms
• Windshield wiper motor
• Windshield wiper mounting arm and pivot shaft assembly
• Windshield wiper blades
• Smart Junction Box (SJB)
• Multifunction switch

Wipers

The wiper system is activated by the multifunction switch. The multifunction switch provides input to the front wiper motor module to activate WASH, LOW, HIGH and INTERMITTENT modes. When the multifunction switch is momentarily placed into WASH mode and then released, there will be a single swipe of the wipers without washer fluid.

Washer

The washer system consists of the washer reservoir and washer pump. When the multifunction switch is placed into the WASH mode, the windshield wiper motor integral electronics activate the washer pump to direct washer fluid to the windshield. When the front windshield washer system is deactivated, an additional 2-3 clearing wipes will be carried out followed by one final courtesy wipe a few seconds later to clear any remaining fluid that is dripping down from the top of the windshield.

NOTE: The SJB may also be identified as the Generic Electronic Module (GEM).

Wiper Activated Headlamps (if equipped with Autolamp System)

If equipped with automatic headlamps, the SJB will illuminate the exterior lamps, including the parking lamps within 10 seconds, when the front wipers are on and the headlamp control is in the AUTOLAMP position. When the wipers are turned off, the exterior lamps will remain on for 30 seconds before turning off.