Washer Jet

Removal

1. Lower the rear part of the hood insulator to access the washer jet-to-washer jet hose C-lock coupler.

2. Disconnect the washer jet-to-washer jet hose. For additional information, refer to C-Lock Coupler in this section.

3. NOTICE: When prying on a component, a non-marring tool must be used or damage to the component may occur.

   Remove the washer jet.
   • Insert a sturdy plastic card between the washer jet and the hood. Press forward to release the retaining clip.

Installation

1. Place the washer jet tab in the hood and press forward until a click is heard.

2. NOTE: Verify the washer jet hose connector lock ring is in the locked position.

   Connect the washer jet hose to the washer jet.

3. Position the hood insulator.