SECTION 303-00: Engine System — General Information
2014 Mustang Workshop Manual
GENERAL PROCEDURES
Procedure revision date: 01/07/2013

Cylinder Block Distortion


Special Tool(s)
Feeler Gauge Set
303-D027 (D81L-4201-A) or equivalent

NOTE: Refer to the appropriate Section 303-01 for the specification.

  1. NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the Straightedge is 61 cm (24 in) long, the machined edge must be flat within 0.010 mm (0.0004 in) from end to end.

    Use a Straightedge and a Feeler Gauge Set to inspect the cylinder block for flatness.