SECTION 303-01A: Engine — 3.7L
2014 Mustang Workshop Manual
IN-VEHICLE REPAIR
Procedure revision date: 01/07/2013
Engine Oil Pressure (EOP) Switch
Material
Item
Specification
Motorcraft® Thread Sealant with PTFE
TA-24
WSK-M2G350-A2
Removal and Installation
Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
Remove the
EOP
switch.
To install, tighten to 14 Nm (124 lb-in) then an additional 180 degrees.
To install, reverse the removal procedure.
Apply thread sealant with PTFE to the
EOP
switch threads prior to installation.