SECTION 303-01C: Engine — 5.8L (4V)
2014 Mustang Workshop Manual
IN-VEHICLE REPAIR
Procedure revision date: 01/07/2013

Crankshaft Front Seal


Special Tool(s)
Installer, Crankshaft Front Oil Seal
303-635
Installer, Crankshaft Vibration Damper
303-102 (T74P-6316-B)
Installer, Front Cover Oil Seal
303-335 (T88T-6701-A)
Remover, Oil Seal
303-409 (T92C-6700-CH)

Material
Item Specification
Motorcraft® SAE 5W-50 Full Synthetic Motor Oil
XO-5W50-QGT 		WSS-M2C931-B

Removal

  1. Remove the crankshaft pulley. For additional information, refer to Crankshaft Pulley in this section.

  1. NOTICE: Use care not to damage the engine front cover or the crankshaft when removing the seal.

    Using the Oil Seal Remover, remove the crankshaft front oil seal.

Installation

  1. Lubricate the engine front cover and the crankshaft front seal inner lip with clean engine oil.
  1. Using the Crankshaft Vibration Damper Installer, Front Cover Oil Seal Installer and the Crankshaft Front Oil Seal Installer, install the crankshaft front seal.
  1. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley in this section.