Flywheel

Removal

1. Remove the clutch. For additional information, refer to Section 308-01 .

2. Remove the 8 flywheel bolts.

3. NOTICE: The flywheel is a press fit on the crankshaft pilot. Do not use screwdrivers or prybars to remove the flywheel or damage to the flywheel or engine may occur.

   Remove the flywheel.
   • Install 2 of the removed flywheel bolts in the 2 holes shown on the flywheel flange.
   • Tighten the 2 bolts evenly to push the flywheel off the crankshaft pilot.

Installation

1. Position the flywheel on the crankshaft pilot and start the 8 flywheel bolts.

2. Tighten the flywheel bolts evenly in the sequence shown to fully seat the flywheel on the crankshaft pilot.
   • Tighten to 80 Nm (59 lb-ft).

3. Install the clutch. For additional information, refer to Section 308-01 .

4. After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.