Oil Cooler — Body Mounted

Removal and Installation

NOTE: Removal steps In this procedure may contain installation details.

1. Remove the bumper cover. Refer to Section 501-19 .

2. Disconnect the horn electrical connector and wire retainer.

3. Remove the bolt and the horns.
   • To install, tighten to 12 Nm (106 lb-in).

4. Remove the 4 retainers and the front bumper isolator.

5. NOTICE: If metal or aluminum material is present in the oil cooler, mechanical concerns exist. Failure to correct these concerns may cause engine failure. To diagnose mechanical concerns, refer to Section 303-00 .

   Disconnect the 2 oil cooler hoses.

6. Remove the pin type retainer.

7. Remove the 2 nuts for the oil cooler bracket.
   • To install, tighten to 7 Nm (62 lb-in).

8. Remove the bolt and the oil cooler.
   • To install, tighten to 25 Nm (18 lb-ft).

9. To install, reverse the removal procedure.