SECTION 303-01C: Engine — 5.8L (4V)
2014 Mustang Workshop Manual
IN-VEHICLE REPAIR
Procedure revision date: 01/07/2013

Oil Cooler — Engine Mounted


Material
Item Specification
Motorcraft® Metal Surface Prep
ZC-31-A 		—

Removal

  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to Section 100-02 .
  1. Drain the engine cooling system. Refer to Section 303-03A .
  1. Remove the generator. Refer to Section 414-00 .

  1. NOTICE: If metal or aluminum material is present in the oil cooler, mechanical concerns exist. Failure to correct these concerns may cause engine failure. To diagnose mechanical concerns, refer to Section 303-00 .

    Remove the 6 bolts and the oil cooler.

Installation

  1. NOTE: Clean the sealing surfaces with Motorcraft® Metal Surface Prep. Follow the directions on the packaging. Inspect the mating surfaces.

    Using new gaskets, install the oil cooler and the 6 bolts. Tighten in the sequence shown in 2 stages.
  1. Install the generator. Refer to Section 414-00 .
  1. Fill and bleed engine cooling system. Refer to Section 303-03A .