SECTION 303-05: Accessory Drive
2014 Mustang Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 01/07/2013
Accessory Drive Belt Idler Pulley — 5.8L (4V)
Removal and Installation
If equipped, remove the nut and position aside the coolant tube support bracket.
To install, tighten to 9 Nm (80 lb-in).
Rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the coolant pump pulley.
Remove the bolt and the accessory drive belt idler pulley.
To install, tighten to 25 Nm (18 lb-ft).
To install, reverse the removal procedure.
