Supercharger Belt

Removal and Installation

1. Remove the accessory drive belt. For additional information, refer to Accessory Drive Belt — 5.8L (4V) in this section.

2. Rotate the Supercharger (SC) belt tensioner clockwise and remove the SC belt from the SC pulley.

3. NOTE: The SC belt is routed behind the SC belt tensioner.

   Remove the SC belt tensioner bolt, the tensioner and the SC belt.
   • To install, tighten to 48 Nm (35 lb-ft).

4. NOTE: For additional information, refer to Accessory Drive in the Description and Operation portion of this section for correct drive belt routing.

   To install, reverse the removal procedure.