SECTION 205-00: Driveline System — General Information
2014 Mustang Workshop Manual
SPECIFICATIONS
Procedure revision date: 01/07/2013

Material
Item Specification Fill Capacity
Additive Friction Modifier
XL-3 (US); CXL-3 (Canada) 		EST-M2C118-A 4 oz (Traction-Lok® only).
6 oz (If equipped with rear differential oil cooler).
Motorcraft® SAE 75W-140 Synthetic Rear Axle Lubricant
XY-75W140-QL (US); CXY-75W140-1L (Canada) 		WSL-M2C192-A and GL-5 8.8-in rear axle. a b
Motorcraft® SAE 75W-85 Premium Synthetic Hypoid Gear Lubricant
XY-75W85-QL 		WSS-M2C942-A SVT 8.8-in rear axle. a b
Premium Long-Life Grease
XG-1-C or XG-1-K (US); CXG-1-C (Canada) 		ESA-M1C75-B —
Threadlock 262
TA-26 		WSK-M2G351-A6 —
a Service refill capacities are determined by filling the axle to a level of 5mm below the bottom of the filler hole. The vehicle must be on a level surface.
b Vehicles equipped with a rear differential oil cooler. Refer to the procedure.


  General Specifications

Item Specification
Maximum driveshaft runout 0.89 mm (0.035 in)
Maximum pinion flange runout 0.25 mm (0.009 in)
Maximum transmission flange runout 0.20 mm (0.008 in)
Minimum rotational torque (Traction-Lok®) 27 Nm (20 lb-ft)