2014 Mustang Workshop Manual

SECTION 206-03: Front Disc Brake	2014 Mustang Workshop Manual
REMOVAL AND INSTALLATION	Procedure revision date: 01/07/2013

Brake Caliper Anchor Plate

Material
Item	Specification
Metal Brake Parts Cleaner PM-4-A or PM-4-B (US); CPM-4 (Canada)	—
Silicone Brake Caliper Grease and Dielectric Compound XG-3-A	ESE-M1C171-A

Removal and Installation

Remove the brake pads. For additional information, refer to Brake Pads — 2 Piston in this section.

NOTE: Using specified brake cleaner, clean any residual threadlock compound from the anchor plate threads before installing the bolts.
Remove and discard the 2 anchor plate bolts and remove the brake caliper anchor plate.
- To install, tighten new anchor plate bolts to 115 Nm (85 lb-ft).

Inspect the brake caliper anchor plate assembly.
- Check the guide pins and boots for binding and damage.
- Replace worn or damaged pins. Lubricate the pins with the specified grease.
- Install a new brake caliper anchor plate if it is worn or damaged.

To install, reverse the removal procedure.