SECTION 206-04: Rear Disc Brake
2014 Mustang Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 01/07/2013

Brake Caliper Anchor Plate


Material
Item Specification
Metal Brake Parts Cleaner
PM-4-A or PM-4-B (US); CPM-4 (Canada) 		—

Removal

  1. Remove the brake pads. For additional information, refer to Brake Pads in this section.
  1. Remove the 2 brake caliper anchor plate bolts and the brake caliper.

Installation

  1. NOTICE: In order for the brake caliper anchor plate bolts to attain the proper clamp load when installed, the residual threadlock compound must be cleaned out of the bolt threads of the anchor plate.

    Use the specified brake parts cleaner to clean any residual threadlock compound, and any other foreign material, from the threads of the brake caliper anchor plate.
  1. Position the brake caliper anchor plate and install 2 new anchor plate bolts.
  1. Install the brake pads. For additional information, refer to Brake Pads in this section.