Brake Caliper Support Bracket

Removal and Installation

1. Remove the rear axle shaft. For additional information, refer to Section 205-02

2. Remove the 3 bolts and the brake disc shield.
   • To install, tighten to 20 Nm (177 lb-in).

3. NOTE: Make sure the anti-moan bracket holes, the brake caliper support bracket and the brake caliper anchor plate holes line up during installation.

   If equipped, remove the anti-moan bracket.
   • To install, tighten to 35 Nm (26 lb-ft).

4. Remove the 4 brake caliper support bracket nuts, bolts and the bracket.
   • To install, tighten to 68 Nm (50 lb-ft).

5. To install, reverse the removal procedure.