SECTION 206-05: Parking Brake and Actuation
2014 Mustang Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 01/07/2013
Parking Brake Control
Removal and Installation
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to
Section 100-02
.
Remove the floor console. For additional information, refer to
Section 501-12
.
Release the tension on the parking brake cable. For additional information, refer to
Parking Brake Cable Tension Release
in this section.
Disconnect the front parking brake cable from the 2 rear parking brake cables at the equalizer and release the front cable from the body bracket.
Disconnect the parking brake switch electrical connector.
Remove the nut from the parking brake control.
To install, tighten to 17 Nm (150 lb-in).
Remove the 2 bolts from the parking brake control.
To install, tighten to 30 Nm (22 lb-ft).
Remove the parking brake control.
Position the cable and equalizer through the floorpan.
To install, reverse the removal procedure.
Adjust the parking brake cable tension. For additional information, refer to
Parking Brake Cable Adjustment
in this section.
