SECTION 412-01: Climate Control
| 2014 Mustang Workshop Manual
|
SPECIFICATIONS
| Procedure revision date: 01/07/2013
|
| Item | Specification | Fill Capacity |
|---|---|---|
| Motorcraft® PAG Refrigerant Compressor Oil
YN-12-D | WSH-M1C231-B | 118 ml
(4 fl oz) |
| Motorcraft® R-134a Refrigerant
YN-19 (US); CYN-16-R (Canada) | WSH-M17B19-A | 0.60 kg
(21 oz) (1.32 lb) |
General Specifications
| Item | Specification |
|---|---|
| Magnetic Clutch | |
| Clutch air gap | 0.35-0.60 mm (0.014-0.024 in) |
Torque Specifications
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| A/C clutch disc and hub bolt | 20 | — | 177 |
| A/C compressor bolt | 25 | 18 | — |
| A/C compressor fitting nuts (suction and discharge) | 15 | — | 133 |
| A/C compressor nut | 25 | 18 | — |
| A/C compressor stud | 4 | — | 35 |
| A/C pressure relief valve | 10 | — | 89 |
| A/C slim-line fittings | 15 | — | 133 |
| Compressor-to-condenser discharge line bracket bolt | 20 | — | 177 |
| Condenser inlet fitting nut | 15 | — | 133 |
| Condenser outlet fitting nut | 15 | — | 133 |
| Cross brace bolts | 35 | 26 | — |
| Evaporator outlet line bracket bolt | 7 | — | 62 |
| Evaporator outlet line fitting nut | 15 | — | 133 |
| Exterior heater core and evaporator core housing nuts | 7 | — | 62 |
| Ground strap bolts (at RH shock tower) | 10 | — | 89 |
| High-pressure Schrader-type valve | 2.5 | — | 22 |
| High-pressure service gauge port valve cap | 0.8 | — | 7 |
| High-pressure service gauge port valve extension bracket bolt | 7 | — | 62 |
| Interior heater core and evaporator core housing nut | 9 | — | 80 |
| Junction box bolt | 8 | — | 71 |
| Junction box nut | 8 | — | 71 |
| Lower condenser nut | 9 | — | 80 |
| Low-pressure Schrader-type valve | 1.8 | — | 16 |
| Low-pressure service gauge port valve cap | 0.8 | — | 7 |
| Lower underbody shield bolts | 10 | — | 89 |
| PCM bracket bolts | 8 | — | 71 |
| PCM bracket studs | 8 | — | 71 |
| Positive battery cable nut (at junction box) | 10 | — | 89 |
| Receiver/drier bolt | 9 | — | 80 |
| Thermostatic Expansion Valve (TXV) bolts | 7 | — | 62 |
| TXV fitting nut | 15 | — | 133 |
| Upper condenser bolt | 9 | — | 80 |
| Wire harness retainer bolt | 20 | — | 177 |