SECTION 415-00: Information and Entertainment Systems
2014 Mustang Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 01/07/2013

Universal Serial Bus (USB) Cable and Port

Removal and Installation

  1. Remove the floor console. For additional information, refer to Section 501-12 .
  1. Remove the Audio Front Control Module (ACM). For additional information, refer to Audio Control Module (ACM) in this section.
  1. Release the tabs and lower the glove compartment completely.
  1. Disconnect the Universal Serial Bus (USB) cable connection at the Accessory Protocol Interface Module (APIM).
  1. Remove the USB cable and port.
  1. To install, reverse the removal procedure.