Striker - Hood (Remove and Replace)

Correction code 1135290211352902

DRAFT

from-cad
Warning:

This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components.

Do not redistribute this content. Provide corrections and feedback to servicemanualfeedback@tesla.com.

Remove

  1. Open the hood.
  2. Use masking tape to mark the location of the hood striker on the hood assembly.
  3. Remove the bolts that secure the striker to the hood, and then remove the striker from the hood.
    Torque 18 Nm
1Open the hood.
2Use masking tape to mark the location of the hood striker on the hood assembly.
3Remove the bolts that secure the striker to the hood, and then remove the striker from the hood.
Torque 18 Nm

Install

  1. Install the striker on to the hood, but do not fully torque the bolts.
    Note: Use the masking tape as a guide.
  2. Close the hood and verify alignment.
  3. Open the hood and adjust the striker position as necessary.
  4. Repeat step 2 and step 3 until alignment is satisfactory.
  5. Fully tighten the bolts.
  6. Remove the masking tape, and then close the hood.
1Install the striker on to the hood, but do not fully torque the bolts.
Note: Use the masking tape as a guide.
2Close the hood and verify alignment.
3Open the hood and adjust the striker position as necessary.
4Repeat step 2 and step 3 until alignment is satisfactory.
5Fully tighten the bolts.
6Remove the masking tape, and then close the hood.