Applique - B-Pillar - LH (Remove and Replace)

Correction code 1220010212200102

Remove

  1. Open the LH front and rear doors.
  2. Release the clips that attach the B-pillar applique fastener cover to the vehicle, and then remove the cover.
  3. Remove the bolts that attach the B-pillar applique to the body, but do not remove the applique from the vehicle at this time.
  4. Release the B-pillar applique from the body, and then disconnect the camera connectors from the B-pillar applique.
    Caution:
    Use caution not to damage the camera connector.
  5. Remove the B-pillar applique from the vehicle.
1Open the LH front and rear doors.
2Release the clips that attach the B-pillar applique fastener cover to the vehicle, and then remove the cover.
3Remove the bolts that attach the B-pillar applique to the body, but do not remove the applique from the vehicle at this time.
4Release the B-pillar applique from the body, and then disconnect the camera connectors from the B-pillar applique.
Caution:
Use caution not to damage the camera connector.
5Remove the B-pillar applique from the vehicle.

Install

  1. Connect the camera connectors to the B-pillar applique, and then position the applique onto the vehicle.
  2. Install the bolts that attach the B-pillar applique to the body.
    Torque 5 Nm
  3. Position the B-pillar applique fastener cover onto the vehicle, and then engage the clips that attach the B-pillar applique fastener cover to the vehicle.
  4. Close the LH rear door.
  5. Update the vehicle firmware using a laptop connected to Garage.
  6. Connect a laptop with Toolbox to the vehicle.
  7. Close the LH front door.
  8. Click on the "Dashboard" tab.
  9. Click on "Service Tools".
  10. Click on "DAS Image Capture".
  11. Click on "Capture Image" to check the current settings.
  12. Review the images to make sure all cameras are able to capture images correctly.
  13. Verify that all key cards work on the B-pillar applique as designed.
1Connect the camera connectors to the B-pillar applique, and then position the applique onto the vehicle.
2Install the bolts that attach the B-pillar applique to the body.
Torque 5 Nm
3Position the B-pillar applique fastener cover onto the vehicle, and then engage the clips that attach the B-pillar applique fastener cover to the vehicle.
4Close the LH rear door.
5Update the vehicle firmware using a laptop connected to Garage.
6Connect a laptop with Toolbox to the vehicle.
7Close the LH front door.
8Click on the "Dashboard" tab.
9Click on "Service Tools".
10Click on "DAS Image Capture".
11Click on "Capture Image" to check the current settings.
12Review the images to make sure all cameras are able to capture images correctly.
13Verify that all key cards work on the B-pillar applique as designed.