Bracket - License Plate - Front (NA) (Retrofit)

Correction code 1207010612070106

Retrofit

Animated demonstration
  1. Clean the front center surface of the front fascia.
  2. Remove the backing from the long horizontal tape strip on the new front license plate bracket.
  3. Fold the backing of the vertical tape strips out at a 90 degree angle.
  4. Hold the license plate bracket horizontally and align the locator tab at the bottom lip of the bracket with the center rib of the fascia grille.
  5. Rotate the license plate bracket vertically and press the top edge against the front fascia.
  6. Pull the tape strips out from the sides of license plate bracket, and then press the bracket against the front fascia.
  7. Install the license plate onto the front license plate bracket, and then install the screws that attach the plate to the bracket.
    Torque 3 Nm
1Clean the front center surface of the front fascia.
2Remove the backing from the long horizontal tape strip on the new front license plate bracket.
3Fold the backing of the vertical tape strips out at a 90 degree angle.
4Hold the license plate bracket horizontally and align the locator tab at the bottom lip of the bracket with the center rib of the fascia grille.
5Rotate the license plate bracket vertically and press the top edge against the front fascia.
6Pull the tape strips out from the sides of license plate bracket, and then press the bracket against the front fascia.
7Install the license plate onto the front license plate bracket, and then install the screws that attach the plate to the bracket.
Torque 3 Nm