Actuator - 5-Way Valve (RWD) (Remove and Replace)

Correction code 1830630218306302
  • 1447556-00-AWrench, Diverter Valve, Model 3

SPECIAL TOOLS

Wrench, Diverter Valve, Model 3 (1447556-00-A)

Remove

  1. Disconnect 12V power. See 12V Power (Disconnect and Connect).
  2. Remove the front aero shield. See Panel - Aero Shield - Front (Remove and Replace).
  3. From under the vehicle, disconnect the electrical harness from the 5-way valve actuator connector.
  4. Remove the screws that attach the 5-way valve actuator to the 5-way valve cover, and then remove the actuator from the valve cover.
    Note: The end of the stem shell shaft is exposed.
1Disconnect 12V power. See 12V Power (Disconnect and Connect).
2Remove the front aero shield. See Panel - Aero Shield - Front (Remove and Replace).
3From under the vehicle, disconnect the electrical harness from the 5-way valve actuator connector.
4Remove the screws that attach the 5-way valve actuator to the 5-way valve cover, and then remove the actuator from the valve cover.
Note: The end of the stem shell shaft is exposed.

Install

  1. Examine the end the of the 5-way valve stem shell shaft. One shaft spline is slightly wider than the others.
  2. Mark the wider spline.
  3. Use the diverter valve wrench to align the 5-way valve stem shell shaft with the 5-way valve actuator for assembly.
    Note: When properly aligned, the actuator easily slides over the stem shell shaft.
  4. Install the 5-way valve actuator on the 5-way valve cover, and then install the screws that attach the actuator on the cover.
    Torque 2 Nm
  5. Connect the electrical harness to the 5-way valve actuator connector.
  6. Install the front aero shield. See Panel - Aero Shield - Front (Remove and Replace).
  7. Connect 12V power. See 12V Power (Disconnect and Connect).
  8. Connect a laptop with Toolbox to the vehicle.
  9. Using Toolbox, run the 5-way valve actuator self-test, "TEST-SELF_VCFRONT_X_FIVE-WAY-VALVE."
    Note: This Toolbox routine tests and calibrates the 5-way valve actuator.
  10. Disconnect the laptop from the vehicle.
1Examine the end the of the 5-way valve stem shell shaft. One shaft spline is slightly wider than the others.
2Mark the wider spline.
3Use the diverter valve wrench to align the 5-way valve stem shell shaft with the 5-way valve actuator for assembly.
Note: When properly aligned, the actuator easily slides over the stem shell shaft.
4Install the 5-way valve actuator on the 5-way valve cover, and then install the screws that attach the actuator on the cover.
Torque 2 Nm
5Connect the electrical harness to the 5-way valve actuator connector.
6Install the front aero shield. See Panel - Aero Shield - Front (Remove and Replace).
7Connect 12V power. See 12V Power (Disconnect and Connect).
8Connect a laptop with Toolbox to the vehicle.
9Using Toolbox, run the 5-way valve actuator self-test, "TEST-SELF_VCFRONT_X_FIVE-WAY-VALVE."
Note: This Toolbox routine tests and calibrates the 5-way valve actuator.
10Disconnect the laptop from the vehicle.