Motor - Seat Height - Driver Seat (Remove and Replace)

Correction code 1301160213011602

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  4. Remove the middle A-Pillar trim panel. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  5. Remove the LH lower A-Pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  6. Remove the driver seat. See Seat - Driver (Remove and Replace).
  7. Disconnect the electrical harness from the seat height motor connector.
  8. Remove and discard the patchbolt that attaches the seat height motor to the seat cushion frame.
    Torque 23 Nm
  9. Remove and discard the patchbolt that attaches the seat height motor to the rear RH link, and then remove the motor from the seat.
    Torque 18 Nm
    Tip: Slide the seat height motor down and out, away from the wiring harness.
1Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
2Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
3Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
4Remove the middle A-Pillar trim panel. See Trim - A-Pillar - Middle - LH (Remove and Replace).
5Remove the LH lower A-Pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
6Remove the driver seat. See Seat - Driver (Remove and Replace).
7Disconnect the electrical harness from the seat height motor connector.
8Remove and discard the patchbolt that attaches the seat height motor to the seat cushion frame.
Torque 23 Nm
9Remove and discard the patchbolt that attaches the seat height motor to the rear RH link, and then remove the motor from the seat.
Torque 18 Nm
Tip: Slide the seat height motor down and out, away from the wiring harness.

Install

Installation procedure is the reverse of removal, except for the following:

  • Replace all patchbolts.