Sensor - Wheel Speed - ABS - Rear - LH (Remove and Replace)

Correction code 3310070233100702

Remove

  1. Remove the rear LH wheel. See Wheel (Remove and Install).
  2. Release the clip that attaches the rear ABS wheel speed sensor connector to the subframe, and then disconnect the subframe harness from the connector.
    Tip: Use a mechanical pickup tool to hold the connector in place, and then release the connector clip with a screwdriver.
  3. Release the clip and remove the grommet that attach the rear LH ABS wheel speed sensor cable to the rear knuckle and bracket.
  4. Remove and discard the bolt that attaches the rear LH ABS wheel speed sensor to the knuckle, and then remove the sensor from the vehicle.
1Remove the rear LH wheel. See Wheel (Remove and Install).
2Release the clip that attaches the rear ABS wheel speed sensor connector to the subframe, and then disconnect the subframe harness from the connector.
Tip: Use a mechanical pickup tool to hold the connector in place, and then release the connector clip with a screwdriver.
3Release the clip and remove the grommet that attach the rear LH ABS wheel speed sensor cable to the rear knuckle and bracket.
4Remove and discard the bolt that attaches the rear LH ABS wheel speed sensor to the knuckle, and then remove the sensor from the vehicle.

Install

  1. Install the rear LH ABS wheel speed sensor to the knuckle, and then install a new bolt to attach the sensor to the knuckle.
    Torque 5 Nm
  2. Fasten the clip and install the grommet that attach the rear LH ABS wheel speed sensor cable to the rear LH knuckle and bracket.
    Caution:
    Perform a push-pull check on the clip and grommet to make sure they are securely fastened to the knuckle and bracket.
  3. Connect the subframe harness to the rear ABS wheel speed sensor connector, and then fasten the clip that attaches the connector to the subframe.
  4. Install the rear LH wheel. See Wheel (Remove and Install).
1Install the rear LH ABS wheel speed sensor to the knuckle, and then install a new bolt to attach the sensor to the knuckle.
Torque 5 Nm
2Fasten the clip and install the grommet that attach the rear LH ABS wheel speed sensor cable to the rear LH knuckle and bracket.
Caution:
Perform a push-pull check on the clip and grommet to make sure they are securely fastened to the knuckle and bracket.
3Connect the subframe harness to the rear ABS wheel speed sensor connector, and then fasten the clip that attaches the connector to the subframe.
4Install the rear LH wheel. See Wheel (Remove and Install).