Fluid Coupling (55 Degrees) - Rear Drive Unit (Remove and Replace)

Correction code 4001400240014002
  • 1135762-00-AKit, Svc Plug, Cooling Hose, Model 3

SPECIAL TOOLS

Kit, Svc Plug, Cooling Hose, Model 3 (1135762-00-A)

Remove

  1. Remove the mid aero shield panel. See Panel - Aero Shield - Mid (Remove and Replace).
  2. Place a coolant drain container underneath the rear drive unit.
  3. Release the clip that attaches the hose to the 55 degree fluid coupling, and then remove the hose.
  4. Insert a plug in the hose.
  5. Remove the fastener that attaches the 55 degree fluid coupling to the rear drive unit.
    Torque 6 Nm
  6. Remove the 55 degree fluid coupling from the rear drive unit.
  7. Insert a plug in the rear drive unit 55 degree fluid coupling opening.
1Remove the mid aero shield panel. See Panel - Aero Shield - Mid (Remove and Replace).
2Place a coolant drain container underneath the rear drive unit.
3Release the clip that attaches the hose to the 55 degree fluid coupling, and then remove the hose.
4Insert a plug in the hose.
5Remove the fastener that attaches the 55 degree fluid coupling to the rear drive unit.
Torque 6 Nm
6Remove the 55 degree fluid coupling from the rear drive unit.
7Insert a plug in the rear drive unit 55 degree fluid coupling opening.

Install

Installation procedure is the reverse of removal, except for the following:

Caution:

Replace all patchbolts.


Caution:
Perform a push-pull test to verify that the hose is fully seated.