Hose - Inverter to Heat Exchanger - Front Drive Unit (Remove and Replace)

Correction code 3920100239201002

Remove

  1. Remove the front subframe assembly from the vehicle. See Subframe Assembly - Front (Dual Motor) (Remove and Install).
  2. Release the clip that attaches the front drive unit inverter-heat exchanger hose to the inverter coolant outlet, and then disconnect the hose.
  3. Release the clip that attaches the front drive unit inverter-heat exchanger hose to the heat exchanger coolant inlet, and then disconnect the hose.
  4. Release the clips that attach the front drive unit inverter-heat exchanger hose to the exterior of the front drive unit, and then remove the hose from the front drive unit.
1Remove the front subframe assembly from the vehicle. See Subframe Assembly - Front (Dual Motor) (Remove and Install).
2Release the clip that attaches the front drive unit inverter-heat exchanger hose to the inverter coolant outlet, and then disconnect the hose.
3Release the clip that attaches the front drive unit inverter-heat exchanger hose to the heat exchanger coolant inlet, and then disconnect the hose.
4Release the clips that attach the front drive unit inverter-heat exchanger hose to the exterior of the front drive unit, and then remove the hose from the front drive unit.

Install

Installation procedure is the reverse of removal.

Caution:
Perform a push-pull test to verify that the hose is fully seated.