Cover - Footwell - Driver (Remove and Replace)

Correction code 1405530214055302

Remove

  1. Release the clips and remove the screw that attach the driver footwell cover to the vehicle.
    Torque 2.5 Nm
  2. Disconnect the electrical connector from the puddle light, and then disconnect the diagnostic cable from the driver footwell cover.
  3. APAC vehicles only: Disconnect the OBD-II connector from the driver footwell cover.
  4. Release the tabs that attach the driver footwell cover to the vehicle, and then remove the footwell cover from the vehicle.
1Release the clips and remove the screw that attach the driver footwell cover to the vehicle.
Torque 2.5 Nm
2Disconnect the electrical connector from the puddle light, and then disconnect the diagnostic cable from the driver footwell cover.
3APAC vehicles only: Disconnect the OBD-II connector from the driver footwell cover.
4Release the tabs that attach the driver footwell cover to the vehicle, and then remove the footwell cover from the vehicle.

Install

  1. Reconnect the diagnostic cable to the driver footwell cover, and then reconnect the electrical connector to the puddle light.
  2. APAC vehicles only: Reconnect the OBD-II connector to the driver footwell cover.
  3. Position the footwell cover for installation by securing the front tabs (x3) to the driver side knee air bag assembly, and then install the clips (x2) and the screw (x1) that attach the driver footwell cover to the vehicle. (Non-North American vehicles do not have knee airbags, so the driver footwell cover is secured by one clip and two T20 screws.)
    Torque 2.5 Nm
1Reconnect the diagnostic cable to the driver footwell cover, and then reconnect the electrical connector to the puddle light.
2APAC vehicles only: Reconnect the OBD-II connector to the driver footwell cover.
3Position the footwell cover for installation by securing the front tabs (x3) to the driver side knee air bag assembly, and then install the clips (x2) and the screw (x1) that attach the driver footwell cover to the vehicle. (Non-North American vehicles do not have knee airbags, so the driver footwell cover is secured by one clip and two T20 screws.)
Torque 2.5 Nm