Harness - Drive Unit - Front (Remove and Replace)

Correction code 1710120217101202

Remove

  1. Partially raise the vehicle to a comfortable working height. See Raise Vehicle - 2 Post Lift.
  2. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  3. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  4. Disconnect 12V power. See 12V Power (Disconnect and Connect).
  5. Fullly raise the vehicle.
  6. Remove the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
  7. Release the grey locking tab, and then press on the tab to disconnect the front drive unit logic connector near the LH side of the front subframe.
  8. Release the locking tab, and then push the handle downward to disconnect the front drive unit inverter logic connector.
  9. Release the red locking tab, and then press down on the tab to disconnect the resolver logic connector.
  10. Release the grey locking tab, and then press down on the tab to disconnect the oil pump connector.
  11. Release the clip that attaches the front drive unit harness to the front drive unit motor.
  12. Release the clips that attach the front drive unit harness to the front subframe.
    Other assemblies hidden for clarity
  13. Release the clips that attach the front drive unit harness to the inverter.
  14. Remove the front drive unit harness from the front subframe.
1Partially raise the vehicle to a comfortable working height. See Raise Vehicle - 2 Post Lift.
2Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
3Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
4Disconnect 12V power. See 12V Power (Disconnect and Connect).
5Fullly raise the vehicle.
6Remove the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
7Release the grey locking tab, and then press on the tab to disconnect the front drive unit logic connector near the LH side of the front subframe.
8Release the locking tab, and then push the handle downward to disconnect the front drive unit inverter logic connector.
9Release the red locking tab, and then press down on the tab to disconnect the resolver logic connector.
10Release the grey locking tab, and then press down on the tab to disconnect the oil pump connector.
11Release the clip that attaches the front drive unit harness to the front drive unit motor.
Other assemblies hidden for clarity
12Release the clips that attach the front drive unit harness to the front subframe.
13Release the clips that attach the front drive unit harness to the inverter.
14Remove the front drive unit harness from the front subframe.

Install

Installation procedure is the reverse of removal, except for the following:

Caution:
Perform a push-pull test on the front drive unit harness connectors to verify that the connectors are fully attached.