SECTION 204-02: Rear Suspension
2014 Mustang Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 01/07/2013

Stabilizer Bar Link


Material
Item Specification
Silicone Spray Lubricant
XL-6 		ESR-M13P4-A


Item Part Number Description
1 5C488 Stabilizer bar link (2 required) (also part of 5A771)
2 5A771 Stabilizer bar

Removal and Installation

  1. Remove the stabilizer bar. For additional information, refer to Stabilizer Bar in this section.

  1. NOTE: To aid removal, apply a light coat of silicone lubricant to the necessary parts of the rear stabilizer bar and the inside diameter of the stabilizer bar bushing and link.

    Remove the stabilizer bar bushing and link.
    1. Slide the bushing off of the stabilizer bar.
    1. Slide the link off of the stabilizer bar.

  1. NOTE: The stabilizer bar links and bushings are vehicle specific (convertible and coupe). Make sure the correct link and bushing go on the correct vehicle.

    NOTE: To aid installation, apply a light coat of silicone lubricant to the necessary parts of the rear stabilizer bar and the inside diameter of the stabilizer bar bushing and link.

    To install, reverse the removal procedure.