SECTION 303-01C: Engine — 5.8L (4V)
2014 Mustang Workshop Manual
IN-VEHICLE REPAIR
Procedure revision date: 01/07/2013

Oil Pump


Material
Item Specification
Motorcraft® Metal Surface Prep
ZC-31-A 		—

Removal

NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.

  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to Section 100-02 .
  1. Remove the timing drive components. Refer to Timing Drive Components .
  1. Remove the oil pan. Refer to Oil Pan .
  1. Remove the 3 bolts and the oil pump.

Installation

  1. NOTICE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths.

    Clean the sealing surfaces with metal surface prep. Follow the directions on the packaging.
  1. Install the oil pump and 3 bolts. Tighten the bolts in the sequence shown.
  1. Install the oil pan. Refer to Oil Pan .
  1. Install the timing drive components. Refer to Timing Drive Components .